This paper has monitored a number of parameters of hydraulic ITH drilling and evaluated the data. For rock mechanics modeling, a dynamic numerical tool has been developed to describe rock damage and failure, including rock crushing by compressive bit load, rock fracturing by both shearing and tensile forces, and rock weakening by repetitive compression-tension loading. Nevertheless, the corresponding ANN models Model I and II have much stronger correlation coefficients than those of the regression models and their estimation capabilities are very good, as shown in Figures 9 and The monitored data are transferred from the rig to the RRA rig remote access server by a wireless network. Compared to the some previous models, the derived models include operational variables such as operational pressure and feed pressure.
Log in to your subscription
Figure 1 shows a tricone bit with tungsten carbide inserts produced by Atlas Copco Atlas Copco, , which makes up the cutting elements of the rock bit and comprises: Proceedings of an International Conference Submersible Technology: The skewness values of each test are also given. Comfort and safety Operators appreciate the spacious cab. Open Access This article is freely available re-usable Minerals , 7 7 , ; doi:
Improving Rate of Penetration - Fordia
Core Sampling in Geotechnical Drilling. It is measured by the Pearson residual [ 34 ], as shown in Equation 3: Drillability of rocks in percussive drilling from energy per unit volume as determined with a microbit. It is obvious that the proposed fuzzy model can be improved upon with more data obtained from further drilling operations. The system had to be easy to use, safe and not require assistance from mine equipment. This research has shown that the penetration rate for percussive drills can be reliably estimated from the operational pressure, feed pressure, Shore hardness, and density by using ANN analysis. After analyses, information has been shared with industry experts to validate the results.
The drilling operation is carried out with rotary drill rigs and rolling tricone bits. Determining seven rock properties is time-consuming and expensive. Regression analysis Firstly, the correlation matrix was constructed for the rock properties to determine whether high redundancies exist between these independent variables. According to Tamrock, rotary blast-hole drill operations depend on four important elements: Although the correlation coefficient and the estimation capability of Equation  are not good, the corresponding ANN model Model III has a very strong correlation coefficient and its estimation capability is good, as shown in Figure Figure 13 presents the loading plot for the first and second principal components.